How to apply a Sony Xperia 10 III skin
Sony Xperia 10 III skin installation video
Follow our Xperia 10 III video before peeling your skin. Check both the model number and generation against your order, then compare each supplied piece.
Fitting a clear skin? Use our clear-skin guide and check device suitability before wet fitting.
Pause and replay as you fit. Watch on YouTube ↗
Can't see your model listed? Use a similar model with the same skin type for the basic fitting method. Cut-outs and alignment may differ, so use a skin made for your exact device.
Before you start
Confirm Xperia 10 III
Match your exact model and coverage to the order. Leave unused sections on the backing.
Clean and dry
Switch off and unplug. Follow the manufacturer's surface-care advice and allow fitting surfaces to dry.
Watch first
Use clean hands and good lighting, with your supplied instructions beside you.
Fitting your Xperia 10 III skin
Use the video for precise placement and application order. Fit only the pieces you ordered.
-
Check the whole alignment
Compare the camera opening and outside margins before pressing firmly.
-
Smooth progressively
Follow the backing-removal method shown. Keep fingers away from the adhesive.
-
Finish shaped edges
Use gentle hairdryer warmth only where instructed. Do not stretch a piece to fit or make your phone hot.
-
Inspect before use
Keep all controls, sensors and ports clear. Check that a case does not catch a fitted edge.
Installation questions
Where is the Xperia 10 II guide?
Use the Xperia 10 II fitting video for that generation. Always use its model-specific skin.
What about bubbles or lifting?
Do not use a pin or extra force. Read our troubleshooting guide.
All installation guides →