How to apply an Apple Watch skin
Apple Watch skin installation video
Follow our Apple Watch fitting video and take your time with the small exterior pieces. Confirm the watch series, case size and coverage on your order before removing the backing.
Watch on YouTube ↗Before you start
Check series and size
Match both details to your order. Identify each piece while it is still on the backing; do not assume similar-sized watches share a skin.
Clean and dry
Remove the watch from your wrist, power it off and disconnect charging. Follow Apple's cleaning advice and let the fitting surfaces dry.
Work with care
Use clean, dry hands and good lighting. Follow the supplied method and avoid handling the adhesive on these narrow sections.
Fitting your Apple Watch skin
-
Compare the cut-outs
Check crown, button and perimeter alignment before firm pressure. Do not stretch a small piece to make it reach.
-
Apply progressively
Use the backing-removal method shown and fit only the intended exterior surfaces. Keep unused pieces on the backing.
-
Finish the curves gently
Follow the video and supplied instructions for shaped edges. Do not use a heat gun or overheat the watch.
-
Check every clearance
Leave the display, sensors, speakers, microphones, charging surface and controls clear. Check that the crown and band attachments move normally.
Installation questions
What if a small edge will not stay down?
Stop before repeatedly pulling it. Check model and alignment, then send a close-up so we can advise without damaging the piece.
Can I cover the back sensors?
No. Apply only to the intended surfaces and keep sensors and the charging area unobstructed.