How to apply an Huawei P10 skin
Watch first. Fit with confidence.
Huawei P10 skin installation video
Follow the Huawei P10 fitting video before you begin. Check that your order is for P10 rather than P10 Plus, then identify the pieces included in your chosen coverage.
Fitting a clear skin? Use the clear-skin wet-fitting guide instead of these dry-vinyl reminders.
Pause and replay each stage. Watch on YouTube ↗
Can't see your model listed? Use a similar model with the same skin type for the basic fitting method. Cut-outs and alignment points may differ: always use a skin made for your exact device. Clear skins need the separate wet-fitting guide.
A little preparation goes a long way
Before you start
Check your P10
Match your order to the exact device. Identify each piece and leave unused sections on the backing.
Clean and dry
Switch off and unplug your phone. Follow the manufacturer's surface-care instructions and let fitting surfaces dry fully.
Watch before peeling
Use clean, dry hands and a well-lit workspace. Keep the supplied instructions beside you.
Fitting your Huawei P10 skin
Follow the video for the precise positioning and application order. Only fit the sections you ordered.
-
Check the starting position
Compare the camera cut-outs and the outer margins before pressing firmly. Do not stretch a piece to make it fit.
-
Apply progressively
Follow the backing-removal method shown and smooth down gradually without touching the adhesive.
-
Finish the edges
Use gentle hairdryer warmth only where instructed. Avoid a heat gun and do not make the phone hot.
-
Inspect before use
Keep camera openings, controls and ports clear. Make sure a case does not drag against a fitted edge.
Installation questions
Is this the P10 Plus guide?
This page is for P10. Use the P10 Plus installation guide for that model and always match the skin to your device.
What if a cut-out will not line up?
Stop and check the model, piece and orientation. Do not cut the skin on the phone or pull it into place.
What about bubbles or wrinkles?
Do not use a pin or extra force. Read our fitting troubleshooting guide.